August 2, 2008
ClickBond Fasteners Streamline Construction
Having just spent a couple days replacing traditional cowling nutplates before coming to the show, I was intimately familiar with laying out the rivet holes for each one, drilling two different hole sizes, deburring, dimpling, and flush-riveting.
Then I heard there was a better way. With the ClickBond system, there's only one hole to drill, some two-part glue to mix up, and the "installation fixture" to hold everything tight until the adhesive fully cures. Time savings?…
To continue reading this entire article you must be a paid subscriber.
Subscribe to KITPLANES
KITPLANES® magazine is the world's #1 homebuilt aviation magazine. Written for people interested in building, flying, designing and maintaining their own amateur-built category, manned aircraft, each issue is packed with need-to-know information.
Already subscribe but haven't registered for all the benefits of the website? Click here.
Subscriber Log In
Forgot your password? Click Here.
IMPORTANT CUSTOMER SERVICE NOTICE TO KITPLANES SUBSCRIBERS:
All mailed correspondence, including subscription invoices, renewals, and gift notices, will bear our address:
PO BOX 8535
Big Sandy, TX 75755
Third parties claiming to be selling KITPLANES subscriptions are not legitimate.