Magazine

With Bose and LightSpeed competing neck and neck (ear to ear?) in the ANR headset arena, author Jack Cowell does a side-by-side comparison to see which model excels.

Motivated by an irresistible bargain and at least a modicum of nostalgia, author Dave Martin recaptures a piece of his earlier flying years when he purchases a twin-engine Lazair ultralight in partnership with two buddies. The Lazair is an unusual design to say the least, and Martin hasnt forgotten how to fly it, so both of his partners will benefit from his experience.

Susan BrunnerSusan spent seven years with her husband building their Lancair IV-P. Her administrative expertise was invaluable for Internet searches and acquisition of parts...

Shopmaster Shop TalkDear Bob Fritz: I have the opportunity to purchase a Shopmaster Lathe/Mill combination similar to yours, but a 1998 model which has...

Building an airplane usually requires a long-term commitment, not entirely dissimilar to the one that is made when saying I do. Yet many builders lose sight of this when building, sometimes even forgetting that they have a spouse. The commitment to the project must be matched by the commitment to maintaining a spousal relationship, and a little forethought and planning can help both builder and spouse enjoy not only the process, but the end result.

One of the final steps in getting your avionics suite to work is installation of some sort of antenna to capture various radio frequencies. Failing to choose the right antenna and install it properly can compromise the whole installation. Rather than focusing on the intricacies of antenna design, the author discusses the merits of internal versus external for particular equipment plus where to place them; by Stein Bruch

What do you do when your horizontal stabilizer isn't exactly horizontal? First, you check that the fuselage is level. If this confirms that the stabilizer is indeed slightly off, remove it and apply heat. Sounds simple, but there's a right and a wrong way to go about it, and author Bob Fritz describes the most effective method to straighten things out.

Builders share their successes.

In our continuing series, author Bob Fritz explains how to use a boring head to drill odd-size or big holes. Hint 1: The bigger the hole, the slower the going. Hint 2: The traveling rest, which moves with the cutting tool, braces the material in two directions to minimize flexing.

You have your off-grid hangar on a solar array, but how to harness its power? Thats what Columnist Jim Weir tackles this month, with an array that tracks the sun to maximum effect.